Hot Rods USA, Inc.
Brakes, Chassis, Suspensions
Rods, Customs, & More
1-888-875-6666

 

 

Bill's 1100 Series Brackets


The 1100 series is designed for the Late Style heads (1970 and later)

The brackets mount using only the existing factory drilled holes found on the front of the heads.3 on the drivers side and 1 on the passenger side, Therefore no drilling or tapping is required.  They are positioned over the exhaust manifold and the outside edge of the valve covers.

These brackets can be used with the short or long water pumps.

The alternator used is a G. M. and the air conditioner compressor is a Sanden SD-508

Stock steel or aluminum pulleys can be used with the set up

Brackets are available in Black Powder Paint (standard finish), Chrome Plated (additional cost) or Bare Steel (reduced cost). All brackets come completely assembled with an adjusting arm, all the necessary bolts, illustrated instructions, belt size recommendations and belt adjusting tips for easy installation.

 


Please Check Application Table.
Quantity

Store HomeAbout Hot Rods USAShippingReturnsPrivacy Policy
Email moonmr@hotrodsusa.com for questions or comments. Contact us toll free at (888) 875-6666 or at (360) 210-5376. We appreciate your patronage. This site is protected by copyright and trademark laws under US and International law. All rights reserved. © 2003-2005 Hot Rods USA, Inc. No reproduction without written approval. Copyrights held by their respective owners. Information and pricing subject to change without notice.