Hot Rods USA, Inc.
Brakes, Chassis, Suspensions
Rods, Customs, & More
1-888-875-6666

 

 

Bill's 600 Series Brackets


The 600 series is designed for the Small Block Chevy using the Late Style heads  (1970 and later)

The brackets mount to the front face of the heads using only the existing factory drilled holes: 3 on the drivers side and 1 on the passengers side. , therefore no drilling or tapping is required.
Some minor grinding or filling on the valve cover gasket flange may be needed: Please call for more details,
The Alternator and Air Conditioner units are positioned over the valve covers.

Brackets will work with either stock or tall valve covers when ordering we will need to know the height of the valve covers to supply the correct bracket for your set up

These brackets can be used with the short  or long water pumps.

The alternator used is a G. M. and the air conditioner compressor is a Sanden SD-508

Stock steel or aluminum pulleys can be used with the set up

Brackets are available in Black Powder Paint (standard finish), Chrome Plated (additional cost) or Bare Steel (reduced cost). All brackets come completely assembled with an adjusting arm, all the necessary bolts, illustrated instructions, belt size recommendations and belt adjusting tips for easy installation.

 


Please Check Application Table.
Quantity

Store HomeAbout Hot Rods USAShippingReturnsPrivacy Policy
Email moonmr@hotrodsusa.com for questions or comments. Contact us toll free at (888) 875-6666 or at (360) 210-5376. We appreciate your patronage. This site is protected by copyright and trademark laws under US and International law. All rights reserved. © 2003-2005 Hot Rods USA, Inc. No reproduction without written approval. Copyrights held by their respective owners. Information and pricing subject to change without notice.